Rheem EcoSense RETE 7 Instruction Manual download pdf (Page 7)

Location of Unit

NOTICE: Unit must be installed in

a vertical position ONLY with the

water fittings pointing horizontally,

Do not install the unit where it

would routinely be splashed with

water. Electric shock may result.

1. Install the tankless water heater

as close as possible to the

hot water draw-off point, for

example, directly beneath the

sink or next to the shower stall.

2. Install the tankless water heater

in a frost free area. If frost may

occur, remove the unit before

freezing temperatures set in.

3. Leave a minimum of 12" of

clearance on top and bottom of

the unit for servicing.

Mounting The Water Heater

Mounting kit contains sheet metal

screws and supporting brackets in a

plastic bag.

These brackets can be attached to

the back of the heater and allows

the installer to secure the heater to

the wall without the need to open

the front cover.

Make sure to use only the brackets

and screws that are provided in the

mounting kit. The use of longer

screws may damage the unit and

void your warranty.

WALL

MOUNT

BRACKET

LOWER

MOUNT

HOLE

UPPER

MOUNT

HOLE

BACK PANEL

Figure 1

AP15447 Tankless Elelctric.indd 7 11/16/2009 9:24:14 AM

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Rheem EcoSense RETE 7 Instruction Manual Page 7

Comments to this Manuals